Do-It-Yourself garage Floors Epoxy System

If you’ve ever considered using a garage floor epoxy system to safeguard and enhance the look of your storage area floor, there are many things you have to know before purchasing one. Most diy stores carry epoxy floor products made for the do-it-yourselfer and you might have heard differing thoughts on how well they work. Some will say it’s a great product and more will tell you not to waste materials your money. Well, there exists usually a simple explanation as to why this product fails for a few floors.
One reason behind failure is don’t assume all concrete floor is ideal for making use of an epoxy coating. Many floor surfaces have too much hydrostatic pressure, meaning water techniques from the under the slab up to the top in an activity called capillary action. Water then collects on the top, which breaks the bond between the concrete and the epoxy jacket. If the ground “sweats” even though it’s dry exterior or there are areas that appear to stay moist for extended periods of time, then an epoxy coating will almost certainly fail. It will gradually chip and flake away. Even though you don’t think there’s a moisture problem, it’s a good idea to use an efflorescence or salt blocker before the epoxy. This can help prevent wetness from causing problems.

The most possible reason for failure is incorrect surface preparation. The floor must be completely clean and stripped of most other coatings. Any staining or foreign chemicals (oil, grease, paint, etc.) will prevent adequate bonding between the concrete and epoxy, leading to chipping and flaking. Most contractors will apply a overcoat of sealer to a garage area floor after set up. Normally it takes several years for the sealer to wear off completely. This sealer must be removed for epoxy to previous. Although acid etching can be an important step, it will not remove sealer & most stains. Etching will only open up the pores of bare concrete, therefore you should do all cleaning and stripping before etching with acid solution.

Before purchasing a storage area floor epoxy system, you will need to first decide if your floor is right for this. If it sweats often or there are areas that are constantly moist, then just forget about it. Be sure that you are willing to take time to prep the floor properly, as this is the most critical part. In addition, it helps to put one or two coats of clear cement sealer at the top to serve as a wear coat. Water based acrylic sealers are ideal for indoor personal use. Despite any bad reviews you’ve heard about the do-it-yourself storage area floor epoxy system, it’s rather a successful project whether it’s done correctly.

Leave a Reply

Your email address will not be published. Required fields are marked *