application of Epoxy Coatings to a Garage floors

Many times we don’t believe about our garages or pay much attention to the look of them. They are merely a destination to park the automobiles and store the extra boxes of Xmas adornments and such. However, like any other room in your own home your garage area floor needs to be taken health care of.
Due to the utilize it gets, combined with drinking water, gas and olive oil that will unavoidable be spilled after it, garage flooring can certainly become ruined and get started to fall apart over time of use. Epoxy layer is one answer to your garage flooring challenge. Epoxy layer applies a level of sealant and protectant to your concrete garage area floor to help it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor requires a little up-front prep before beginning. The most important step in the procedure is making sure that the floor you are going to apply the epoxy finish onto is free from moisture, residual coloring and doesn’t have a cement sealer or other finishing applied to it.
To check for moisture, have a sheet of vinyl and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and look for any moisture collecting privately of the plastic material facing the ground. If moisture is present, than an epoxy floor coating is not suited as epoxy requires a dried out surface to properly connection with the floors.
Next, we’ll test to make certain the flooring does not have a sealant already applied to it. This test will also check for the existence of oils in the cement as well. Take a cup of normal water and put it straight onto the existing flooring. It will soak in to the floor in a reasonable timeframe. If it beads or just sits on top of the flooring then the flooring has probably already been sealed or has oil impurities. Epoxy floor coverings is not well suited for cement floors that contain already been covered or contain any type of oil residue as it will not bond.
Finally, if you are prepared to spend several months testing an area of your storage floor for suitability to installing epoxy floor coverings you can paint a small area with regular, oil-based teeth enamel. If this test area lasts for several a few months then it is likely an epoxy covering can last as well. However, if you decide to proceed with applying the epoxy covering you will need to eliminate this enamel finish which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *