Applying Epoxy Coatings to any Garage floor

Many times we don’t think about our garages or pay much focus on the look of them. They are simply just a spot to park the vehicles and store the extra boxes of Holiday designs and such. However, like any other room in your own home your garage floor must be taken attention of.
Due to the make use of it gets, combined with normal water, gas and olive oil that will inevitable be spilled upon it, garage floors can simply become damaged and start to break apart after a few years useful. Epoxy coating is one answer to your garage floor challenge. Epoxy covering applies a layer of sealant and protectant to your concrete storage floor to help it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor coverings requires a little up-front preparation before beginning. The most important step in the procedure is making sure that the floor you are going to apply the epoxy finish onto is free of moisture, residual paint and doesn’t have a concrete sealer or other finishing applied to it.
To test for moisture, have a sheet of plastic material and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and check for any moisture collecting on the side of the clear plastic facing the floor. If moisture exists, than an epoxy floor coating is not suited as epoxy requires a dry out surface to properly relationship with the floor coverings.
Next, we’ll test to be sure the flooring doesn’t have a sealant already applied to it. This test will also look for the occurrence of oils in the concrete as well. Take a cup of drinking water and put it immediately onto the prevailing flooring. It should soak into the floor in a reasonable amount of time. If it beads or perhaps sits together with the flooring then the floor has probably already been sealed or is made up of oil contaminants. Epoxy floor is not ideal for cement floors that have already been closed or contain any type of petrol residue as it will not bond.
Finally, if you are prepared to spend several months testing a location of your storage floor for suitability to installing epoxy floor coverings you can color a small area with regular, oil-based teeth enamel. If this test area is maintained for several calendar months then chances are an epoxy layer can last as well. However, if you decide to proceed with making use of the epoxy coating you’ll need to remove this enamel covering that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *