Awesome garage area Floors Epoxy System

If you’ve ever before considered by using a storage floor epoxy system to protect and improve the look of your car port floor, there are many things you have to know before purchasing one. Most home improvement stores take epoxy floor products created for the do-it-yourselfer and you might have heard differing ideas on how well they work. Some will say it’s a fantastic product and others will tell you not to waste your money. Well, you can find usually a fairly easy explanation as to the reasons the product fails for some floors.
One reason for failure is not every concrete floor is suitable for applying an epoxy layer. Many flooring have too much hydrostatic pressure, meaning water movements from the under the slab up to the surface in an activity called capillary action. Moisture then gathers on the surface, which breaks the relationship between the cement and the epoxy jacket. If the floor “sweats” even when it’s dry outside the house or there are areas that seem to stay moist for long periods of time, then an epoxy covering will likely fail. It’ll slowly but surely chip and flake away. Even if you don’t think there’s a moisture problem, it’s a good idea to apply an efflorescence or sodium blocker prior to the epoxy. This will help prevent moisture content from causing problems.

The most probable reason for failure is incorrect surface preparation. The floor must be completely clean and stripped of all other coatings. Any discolorations or foreign chemicals (oil, grease, paint, etc.) will prevent adequate bonding between your cement and epoxy, leading to chipping and flaking. Most companies will apply a overcoat of sealer to a storage floor after installation. It can take several years for the sealer to wear off completely. This sealer must be removed for epoxy to previous. Although acid solution etching is an important step, it will not remove sealer & most stains. Etching is only going to open up the pores of bare cement, therefore you should do all cleaning and stripping before etching with acid.

Before investing in a car port floor epoxy system, you need to first decide if your floor is right for it. If it sweats often or there are areas that are constantly wet, then just forget about it. Make sure that you are prepared to take time to prep the ground properly, as this is actually the most significant part. In addition, it helps to put a couple of jackets of clear concrete sealer at the top to provide as a wear cover. Water established acrylic sealers are suitable for indoor personal use. Despite any bad reviews you’ve found out about the do-it-yourself car port floor epoxy system, it’s rather a successful project whether it’s done correctly.

Leave a Reply

Your email address will not be published. Required fields are marked *