using Epoxy flooring to Your Garage Flooring

Many times we don’t believe about our garages or pay much focus on the look of them. They are merely a destination to park the cars and store the excess boxes of Christmas accessories and such. However, like any other room in your own home your storage floor needs to be taken treatment of.
Due to the use it gets, coupled with normal water, gas and petrol that will inescapable be spilled upon it, garage flooring can simply become damaged and start to fall apart after a few years of use. Epoxy finish is one solution to your garage floors challenge. Epoxy coating applies a part of sealant and protectant to your concrete garage area floor to make it avoid staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor takes a little up-front preparation before beginning. The most important step in the process is making sure that the floor you are going to apply the epoxy layer onto is free of moisture, residual paint and does not have a concrete sealer or other concluding put on it.
To test for moisture, take a sheet of clear plastic and take it to a 3-feet x 3-foot area using masking tape. Keep it there for approximately two times and then remove and look for any moisture collecting privately of the clear plastic facing the floor. If moisture exists, than an epoxy floors covering is not appropriate as epoxy needs a dried out surface to properly bond with the floor.
Next, we’ll test to ensure the flooring does not have a sealant already put on it. This test will also look for the occurrence of oils in the cement as well. Take a cup of water and put it immediately onto the existing flooring. It should soak into the floor in a reasonable timeframe. If it beads or perhaps sits on top of the flooring then your floors has probably recently been sealed or consists of oil pollutants. Epoxy floors is not suited to cement floors that contain already been closed or contain any type of oil residue as you won’t bond.
Finally, if you are prepared to spend almost a year testing an area of your storage area floor for suitability to installing epoxy floor you can coloring a little area with regular, oil-based enamel. If this test area is maintained for several weeks then chances are an epoxy coating can last as well. However, if you decide to proceed with making use of the epoxy layer you’ll need to eliminate this enamel coating that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *