Applying Epoxy Coatings to Your Garage floors

Many times we don’t believe about our garages or pay much focus on their appearance. They are simply just a location to park the autos and store the excess boxes of Xmas adornments and such. However, like any other room in your house your car port floor needs to be taken care and attention of.
Because of the make use of it gets, coupled with normal water, gas and oil that will inescapable be spilled upon it, garage floors can certainly become ruined and begin to break apart after a few years of use. Epoxy layer is one treatment for your garage floor challenge. Epoxy coating applies a layer of sealant and protectant to your concrete car port floor to help it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy floors takes a little up-front prep before beginning. The main step in the procedure is making sure that the ground you are going to apply the epoxy coating onto is free from moisture, residual car paint and doesn’t have a concrete sealer or other concluding applied to it.
To check for moisture, take a sheet of clear plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and check for any moisture collecting privately of the plastic facing the floor. If moisture exists, than an epoxy floors finish is not suitable as epoxy requires a dry surface to properly bond with the floors.
Next, we’ll test to make certain the flooring doesn’t have a sealant already put on it. This test will also look for the existence of oils in the cement as well. Take a cup of water and pour it straight onto the prevailing flooring. It should soak in to the floor in a reasonable amount of time. If it beads or perhaps sits on top of the flooring then the floor has probably recently been sealed or includes oil contaminants. Epoxy floors is not suited to cement floors that have already been covered or contain any kind of essential oil residue as you won’t bond.
Finally, if you are prepared to spend several months testing a location of your storage floor for suitability to putting in epoxy flooring you can paint a small area with regular, oil-based enamel. If this test area endures for several weeks then chances are an epoxy covering can last as well. However, if you decide to proceed with applying the epoxy coating you will need to eliminate this enamel coating which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *