Applying Epoxy flooring to any Garage Flooring

Many times we don’t think about our garages or pay much focus on their appearance. They are merely a spot to park the cars and store the excess boxes of Christmas designs and such. However, like any other room in your house your storage floor must be taken care of.
Because of the make use of it gets, combined with drinking water, gas and engine oil that will inescapable be spilled after it, garage floor can certainly become harmed and commence to break apart after a few years useful. Epoxy covering is one means to fix your garage floor challenge. Epoxy finish applies a part of sealant and protectant to your concrete storage floor to help it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring requires a little up-front planning before beginning. The main step in the process is making sure that the ground you are going to apply the epoxy layer onto is free from moisture, residual paint and does not have a cement sealer or other finishing applied to it.
To test for moisture, have a sheet of plastic and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for approximately two days and then remove and look for any moisture collecting on the side of the clear plastic facing the floor. If moisture exists, than an epoxy floors covering is not suited as epoxy needs a dry out surface to properly bond with the floor.
Next, we’ll test to make sure the flooring does not have a sealant already put on it. This test will also check for the occurrence of oils in the cement as well. Take a cup of water and pour it immediately onto the existing flooring. It will soak into the floor in a reasonable timeframe. If it beads or maybe sits together with the flooring then the floor coverings has probably recently been sealed or is made up of oil contaminants. Epoxy floor coverings is not well suited for cement floors which have already been covered or contain any type of engine oil residue as you won’t bond.
Finally, if you are prepared to spend several months testing a location of your storage area floor for suitability to setting up epoxy floor coverings you can coloring a little area with regular, oil-based teeth enamel. If this test area lasts for several calendar months then chances are an epoxy layer can last as well. However, if you opt to proceed with making use of the epoxy covering you’ll need to eliminate this enamel covering which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *