application of Epoxy flooring to Your Garage floors

Often we don’t believe about our garages or pay much attention to their appearance. They are simply just a destination to park the vehicles and store the excess boxes of Xmas accessories and such. However, like any other room in your house your car port floor needs to be taken health care of.
Because of the put it to use gets, coupled with water, gas and petrol that will inescapable be spilled after it, garage floor may easily become destroyed and get started to fall apart after a few years of use. Epoxy covering is one way to your garage floor challenge. Epoxy coating applies a level of sealant and protectant to your concrete garage floor to make it resist staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor requires a little up-front planning before beginning. The most important step in the process is ensuring the ground you will apply the epoxy covering onto is free of moisture, residual coloring and does not have a concrete sealer or other completing applied to it.
To check for moisture, have a sheet of vinyl and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for approximately two days and then remove and look for any moisture collecting on the side of the vinyl facing the ground. If moisture is present, than an epoxy floors finish is not suited as epoxy needs a dried up surface to properly connection with the flooring.
Next, we’ll test to ensure the flooring does not have a sealant already applied to it. This test will also check for the occurrence of oils in the concrete as well. Take a cup of normal water and pour it directly onto the existing flooring. It should soak into the floor in an acceptable amount of time. If it beads or maybe sits together with the flooring then the floor coverings has probably recently been sealed or contains oil pollutants. Epoxy flooring is not ideal for cement floors which may have already been closed or contain any kind of olive oil residue as you won’t bond.
Finally, if you are prepared to spend almost a year testing a location of your garage floor for suitability to installing epoxy floor you can color a tiny area with regular, oil-based enamel. If this test area lasts for several months then it is likely an epoxy layer will last as well. However, if you decide to proceed with applying the epoxy layer you will need to eliminate this enamel finish that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *