Applying Epoxy Coatings to any Garage floors

Many times we don’t think about our garages or pay much focus on their appearance. They are merely a place to park the vehicles and store the extra boxes of Xmas designs and such. However, like any other room in your own home your garage area floor must be taken care and attention of.
Due to the put it to use gets, combined with water, gas and engine oil that will inescapable be spilled upon it, garage flooring can simply become harmed and get started to fall apart after a few years of use. Epoxy covering is one treatment for your garage floor challenge. Epoxy covering applies a level of sealant and protectant to your concrete car port floor to make it withstand staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy flooring requires a little up-front preparation before beginning. The most important step in the process is making sure that the floor you are going to apply the epoxy covering onto is free from moisture, residual color and does not have a concrete sealer or other finishing put on it.
To check for moisture, have a sheet of clear plastic and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for approximately two times and then remove and check for any moisture collecting on the side of the vinyl facing the ground. If moisture exists, than an epoxy floors covering is not appropriate as epoxy requires a dry surface to properly relationship with the floor coverings.
Next, we’ll test to make sure the flooring doesn’t have a sealant already put on it. This test will also look for the occurrence of natural oils in the concrete as well. Take a cup of drinking water and pour it directly onto the prevailing flooring. It will soak in to the floor in a reasonable timeframe. If it beads or perhaps sits on top of the flooring then the floor coverings has probably already been sealed or has oil pollutants. Epoxy flooring is not suitable for cement floors that contain already been closed or contain any type of engine oil residue as it will not bond.
Finally, if you are prepared to spend almost a year testing an area of your car port floor for suitability to setting up epoxy flooring you can color a little area with regular, oil-based teeth enamel. If this test area is maintained for several a few months then chances are an epoxy covering can last as well. However, if you decide to proceed with making use of the epoxy coating you’ll need to eliminate this enamel coating that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *