Applying Epoxy flooring to the Garage surface

Many times we don’t believe about our garages or pay much attention to their appearance. They are simply just a spot to park the vehicles and store the excess boxes of Christmas decorations and such. However, like any other room in your own home your garage floor needs to be taken treatment of.
Due to the utilize it gets, coupled with drinking water, gas and essential oil that will inescapable be spilled upon it, garage floor coverings may easily become broken and get started to break apart over time of use. Epoxy covering is one way to your garage flooring challenge. Epoxy finish applies a layer of sealant and protectant to your concrete garage floor to help it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor coverings requires a little up-front prep before beginning. The main step in the process is ensuring the ground you will apply the epoxy covering onto is free of moisture, residual color and doesn’t have a concrete sealer or other finishing applied to it.
To test for moisture, have a sheet of clear plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two times and then remove and check for any moisture collecting on the side of the plastic facing the floor. If moisture is present, than an epoxy flooring covering is not suitable as epoxy needs a dried up surface to properly connection with the floor.
Next, we’ll test to be sure the flooring does not have a sealant already applied to it. This test will also check for the presence of natural oils in the concrete as well. Have a cup of drinking water and put it directly onto the existing flooring. It should soak into the floor in a reasonable timeframe. If it beads or perhaps sits on top of the flooring then the floor has probably already been sealed or includes oil contaminants. Epoxy floors is not suited to cement floors which have already been covered or contain any kind of essential oil residue as it will not bond.
Finally, if you are prepared to spend almost a year testing a location of your storage floor for suitability to setting up epoxy flooring you can coloring a small area with regular, oil-based teeth enamel. If this test area continues for several calendar months then chances are an epoxy finish can last as well. However, if you decide to proceed with applying the epoxy finish you’ll need to remove this enamel coating that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *