application of Epoxy Coatings to a Garage surface

Often we don’t think about our garages or pay much focus on the look of them. They are simply just a location to park the cars and store the extra boxes of Christmas accessories and such. However, like any other room in your house your storage area floor needs to be taken care and attention of.
Due to the put it to use gets, combined with water, gas and petrol that will unavoidable be spilled after it, garage flooring can certainly become harmed and commence to fall apart over time useful. Epoxy covering is one answer to your garage floor challenge. Epoxy coating applies a covering of sealant and protectant to your concrete car port floor to help it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring takes a little up-front planning before beginning. The main step in the procedure is making sure that the floor you are going to apply the epoxy layer onto is free from moisture, residual coloring and doesn’t have a cement sealer or other finishing put on it.
To check for moisture, have a sheet of plastic material and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two days and then remove and check for any moisture collecting on the side of the plastic facing the ground. If moisture is present, than an epoxy flooring covering is not ideal as epoxy needs a dried surface to properly connection with the floors.
Next, we’ll test to make sure the flooring doesn’t have a sealant already applied to it. This test will also check for the existence of natural oils in the cement as well. Take a cup of water and put it immediately onto the existing flooring. It should soak into the floor in an acceptable timeframe. If it beads or perhaps sits together with the flooring then the floor has probably recently been sealed or consists of oil impurities. Epoxy floors is not ideal for cement floors which have already been closed or contain any kind of engine oil residue as you won’t bond.
Finally, if you are prepared to spend several months testing an area of your garage floor for suitability to setting up epoxy floor you can color a little area with regular, oil-based enamel. If this test area can last for several months then it is likely an epoxy finish can last as well. However, if you opt to proceed with making use of the epoxy layer you will need to eliminate this enamel finish which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *