Applying Epoxy Coatings to the Garage surface

Many times we don’t believe about our garages or pay much focus on their appearance. They are merely a location to park the autos and store the excess boxes of Xmas decor and such. However, like any other room in your own home your garage area floor must be taken health care of.
Because of the make use of it gets, coupled with water, gas and engine oil that will unavoidable be spilled after it, garage floor coverings can simply become broken and commence to fall apart after a few years useful. Epoxy layer is one solution to your garage floor coverings challenge. Epoxy layer applies a part of sealant and protectant to your concrete car port floor to help it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring requires a little up-front prep before beginning. The main step in the process is making sure that the floor you will apply the epoxy coating onto is free of moisture, residual coloring and does not have a cement sealer or other finishing applied to it.
To check for moisture, take a sheet of plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two times and then remove and look for any moisture collecting on the side of the clear plastic facing the ground. If moisture is present, than an epoxy floors coating is not suitable as epoxy needs a dried out surface to properly bond with the floor coverings.
Next, we’ll test to make sure the flooring does not have a sealant already put on it. This test will also check for the existence of natural oils in the cement as well. Have a cup of drinking water and put it immediately onto the prevailing flooring. It will soak in to the floor in an acceptable timeframe. If it beads or perhaps sits together with the flooring then the floor coverings has probably already been sealed or has oil contaminants. Epoxy flooring is not ideal for cement floors which have already been covered or contain any type of olive oil residue as you won’t bond.
Finally, if you are willing to spend almost a year testing a location of your garage floor for suitability to putting in epoxy flooring you can color a little area with regular, oil-based teeth enamel. If this test area lasts for several calendar months then chances are an epoxy layer can last as well. However, if you decide to proceed with applying the epoxy covering you’ll need to remove this enamel finish that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *