Applying Epoxy flooring to a Garage surface

Often we don’t believe about our garages or pay much focus on their appearance. They are simply just a destination to park the autos and store the excess boxes of Christmas decorations and such. However, like any other room in your house your car port floor needs to be taken treatment of.
Due to the utilize it gets, combined with drinking water, gas and oil that will unavoidable be spilled after it, garage floors can simply become broken and get started to break apart over time of use. Epoxy covering is one means to fix your garage floor challenge. Epoxy coating applies a layer of sealant and protectant to your concrete car port floor to help it resist staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring requires a little up-front planning before beginning. The most important step in the process is ensuring the floor you will apply the epoxy layer onto is free from moisture, residual coloring and does not have a concrete sealer or other finishing put on it.
To test for moisture, take a sheet of plastic and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and check for any moisture collecting privately of the plastic material facing the floor. If moisture exists, than an epoxy floors finish is not suitable as epoxy requires a dried out surface to properly relationship with the floor coverings.
Next, we’ll test to make certain the flooring doesn’t have a sealant already put on it. This test will also look for the presence of oils in the cement as well. Have a cup of water and put it immediately onto the existing flooring. It should soak into the floor in an acceptable timeframe. If it beads or perhaps sits on top of the flooring then your flooring has probably already been sealed or has oil pollutants. Epoxy floor is not ideal for cement floors which have already been sealed or contain any kind of petrol residue as you won’t bond.
Finally, if you are prepared to spend almost a year testing an area of your car port floor for suitability to setting up epoxy floors you can coloring a tiny area with regular, oil-based enamel. If this test area lasts for several a few months then it is likely an epoxy covering will last as well. However, if you opt to proceed with applying the epoxy layer you will need to eliminate this enamel coating that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *