Applying Epoxy paint to a Garage floors

Many times we don’t think about our garages or pay much attention to the look of them. They are merely a place to park the vehicles and store the extra boxes of Christmas accessories and such. However, like any other room in your own home your storage area floor must be taken health care of.
Because of the put it to use gets, combined with drinking water, gas and engine oil that will unavoidable be spilled upon it, garage floors can simply become destroyed and get started to break apart over time useful. Epoxy layer is one way to your garage floor coverings challenge. Epoxy finish applies a layer of sealant and protectant to your concrete storage area floor to help it resist staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor coverings takes a little up-front preparation before beginning. The most important step in the procedure is ensuring the ground you will apply the epoxy finish onto is free from moisture, residual coloring and doesn’t have a cement sealer or other finishing put on it.
To check for moisture, have a sheet of plastic material and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and check for any moisture collecting privately of the clear plastic facing the ground. If moisture exists, than an epoxy floor coverings layer is not suitable as epoxy requires a dry out surface to properly connection with the flooring.
Next, we’ll test to be sure the flooring does not have a sealant already put on it. This test will also check for the occurrence of oils in the cement as well. Take a cup of water and put it immediately onto the existing flooring. It should soak into the floor in an acceptable timeframe. If it beads or maybe sits on top of the flooring then your flooring has probably already been sealed or consists of oil contaminants. Epoxy flooring is not well suited for cement floors which may have already been sealed or contain any kind of engine oil residue as you won’t bond.
Finally, if you are prepared to spend several months testing a location of your storage floor for suitability to putting in epoxy floor you can paint a tiny area with regular, oil-based enamel. If this test area will last for several a few months then chances are an epoxy finish can last as well. However, if you decide to proceed with making use of the epoxy layer you will need to remove this enamel covering which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *