Applying Epoxy paint to the Garage Flooring

Many times we don’t think about our garages or pay much focus on their appearance. They are merely a place to park the cars and store the extra boxes of Christmas decorations and such. However, like any other room in your own home your storage area floor must be taken attention of.
Because of the put it to use gets, combined with normal water, gas and petrol that will unavoidable be spilled after it, garage flooring may easily become destroyed and begin to fall apart after a few years of use. Epoxy finish is one treatment for your garage floors challenge. Epoxy coating applies a level of sealant and protectant to your concrete garage floor to help it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring requires a little up-front planning before beginning. The most important step in the process is making sure that the ground you will apply the epoxy coating onto is free of moisture, residual car paint and does not have a cement sealer or other finishing put on it.
To test for moisture, take a sheet of clear plastic and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two days and then remove and look for any moisture collecting on the side of the plastic material facing the floor. If moisture is present, than an epoxy floor coverings coating is not suitable as epoxy needs a dried out surface to properly bond with the flooring.
Next, we’ll test to make certain the flooring doesn’t have a sealant already applied to it. This test will also look for the existence of oils in the concrete as well. Have a cup of normal water and put it immediately onto the existing flooring. It will soak in to the floor in a reasonable amount of time. If it beads or simply sits on top of the flooring then the flooring has probably recently been sealed or is made up of oil contaminants. Epoxy floor coverings is not ideal for cement floors that have already been closed or contain any kind of olive oil residue as it will not bond.
Finally, if you are prepared to spend several months testing a location of your garage area floor for suitability to installing epoxy flooring you can color a small area with regular, oil-based teeth enamel. If this test area endures for several weeks then chances are an epoxy layer will last as well. However, if you decide to proceed with making use of the epoxy covering you’ll need to remove this enamel finish that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *