application of Epoxy paint to the Garage Flooring

Many times we don’t believe about our garages or pay much attention to the look of them. They are simply just a place to park the cars and store the excess boxes of Christmas decor and such. However, like any other room in your own home your car port floor must be taken care and attention of.
Due to the put it to use gets, combined with water, gas and oil that will inescapable be spilled after it, garage floors can certainly become damaged and commence to break apart after a few years of use. Epoxy layer is one answer to your garage floors challenge. Epoxy finish applies a coating of sealant and protectant to your concrete car port floor to make it resist staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor coverings requires a little up-front planning before beginning. The most important step in the procedure is making sure that the ground you are going to apply the epoxy finish onto is free of moisture, residual car paint and does not have a concrete sealer or other concluding put on it.
To check for moisture, have a sheet of vinyl and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two days and then remove and look for any moisture collecting on the side of the vinyl facing the ground. If moisture exists, than an epoxy flooring covering is not ideal as epoxy needs a dried up surface to properly bond with the floor.
Next, we’ll test to ensure the flooring does not have a sealant already put on it. This test will also look for the presence of oils in the concrete as well. Have a cup of normal water and put it directly onto the prevailing flooring. It should soak into the floor in a reasonable amount of time. If it beads or simply sits together with the flooring then the floor has probably recently been sealed or consists of oil impurities. Epoxy floor is not ideal for cement floors which have already been sealed or contain any type of essential oil residue as it will not bond.
Finally, if you are willing to spend almost a year testing a location of your storage floor for suitability to installing epoxy flooring you can coloring a tiny area with regular, oil-based teeth enamel. If this test area can last for several weeks then chances are an epoxy covering can last as well. However, if you opt to proceed with making use of the epoxy covering you will need to remove this enamel finish which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *