Applying Epoxy Coatings to any Garage Flooring

Often we don’t believe about our garages or pay much attention to their appearance. They are merely a spot to park the cars and store the extra boxes of Christmas adornments and such. However, like any other room in your own home your car port floor must be taken care of.
Because of the put it to use gets, combined with normal water, gas and engine oil that will unavoidable be spilled after it, garage floor can certainly become damaged and start to fall apart over time of use. Epoxy coating is one treatment for your garage floor coverings challenge. Epoxy finish applies a covering of sealant and protectant to your concrete garage floor to make it resist staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring requires a little up-front planning before beginning. The most important step in the process is making sure that the ground you are going to apply the epoxy covering onto is free of moisture, residual car paint and does not have a cement sealer or other completing applied to it.
To test for moisture, take a sheet of plastic and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and look for any moisture collecting on the side of the plastic facing the ground. If moisture is present, than an epoxy flooring layer is not suited as epoxy needs a dry surface to properly connection with the floor.
Next, we’ll test to be sure the flooring does not have a sealant already applied to it. This test will also look for the presence of oils in the cement as well. Have a cup of drinking water and pour it immediately onto the prevailing flooring. It should soak in to the floor in an acceptable timeframe. If it beads or simply sits together with the flooring then your floors has probably already been sealed or is made up of oil contaminants. Epoxy floors is not suited to cement floors that contain already been sealed or contain any kind of engine oil residue as it will not bond.
Finally, if you are prepared to spend almost a year testing an area of your storage area floor for suitability to setting up epoxy floor coverings you can paint a little area with regular, oil-based enamel. If this test area will last for several months then chances are an epoxy covering will last as well. However, if you opt to proceed with applying the epoxy coating you will need to remove this enamel layer that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *