using Epoxy paint to any Garage floors

Many times we don’t believe about our garages or pay much attention to the look of them. They are simply just a destination to park the automobiles and store the excess boxes of Xmas decorations and such. However, like any other room in your house your garage floor must be taken health care of.
Because of the put it to use gets, combined with normal water, gas and petrol that will unavoidable be spilled upon it, garage floor can certainly become ruined and get started to break apart after a few years useful. Epoxy layer is one method for your garage floors challenge. Epoxy finish applies a part of sealant and protectant to your concrete garage area floor to make it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring takes a little up-front planning before beginning. The most important step in the procedure is ensuring the ground you are going to apply the epoxy layer onto is free from moisture, residual coloring and doesn’t have a cement sealer or other finishing put on it.
To test for moisture, have a sheet of plastic material and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and look for any moisture collecting on the side of the clear plastic facing the floor. If moisture is present, than an epoxy floors layer is not ideal as epoxy requires a dried surface to properly connection with the floor.
Next, we’ll test to ensure the flooring does not have a sealant already applied to it. This test will also look for the presence of oils in the concrete as well. Have a cup of normal water and pour it directly onto the existing flooring. It should soak into the floor in an acceptable amount of time. If it beads or perhaps sits on top of the flooring then the floor coverings has probably recently been sealed or is made up of oil impurities. Epoxy floor is not well suited for cement floors which have already been covered or contain any kind of essential oil residue as it will not bond.
Finally, if you are willing to spend almost a year testing an area of your storage area floor for suitability to setting up epoxy floor coverings you can paint a tiny area with regular, oil-based enamel. If this test area lasts for several months then it is likely an epoxy coating will last as well. However, if you opt to proceed with applying the epoxy finish you will need to eliminate this enamel coating that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *