Applying Epoxy Coatings to any Garage floors

Many times we don’t believe about our garages or pay much attention to the look of them. They are simply just a place to park the cars and store the excess boxes of Holiday decorations and such. However, like any other room in your house your garage floor must be taken good care of.
Because of the use it gets, coupled with water, gas and olive oil that will inescapable be spilled upon it, garage floors can easily become damaged and get started to break apart after a few years of use. Epoxy finish is one answer to your garage floor challenge. Epoxy coating applies a level of sealant and protectant to your concrete garage floor to make it resist staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring takes a little up-front preparation before beginning. The most important step in the process is making sure that the ground you are going to apply the epoxy covering onto is free from moisture, residual car paint and does not have a cement sealer or other completing put on it.
To check for moisture, have a sheet of clear plastic and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for about two days and then remove and check for any moisture collecting on the side of the vinyl facing the ground. If moisture is present, than an epoxy floors finish is not appropriate as epoxy requires a dry surface to properly relationship with the floor coverings.
Next, we’ll test to make sure the flooring doesn’t have a sealant already put on it. This test will also check for the existence of oils in the concrete as well. Take a cup of water and pour it immediately onto the prevailing flooring. It will soak in to the floor in an acceptable timeframe. If it beads or perhaps sits together with the flooring then your floor coverings has probably already been sealed or includes oil pollutants. Epoxy floor coverings is not well suited for cement floors which have already been sealed or contain any type of olive oil residue as it will not bond.
Finally, if you are willing to spend almost a year testing an area of your storage floor for suitability to installing epoxy floor coverings you can paint a small area with regular, oil-based teeth enamel. If this test area continues for several a few months then chances are an epoxy finish will last as well. However, if you decide to proceed with making use of the epoxy coating you will need to eliminate this enamel layer that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *