application of Epoxy Coatings to the Garage floor

Often we don’t believe about our garages or pay much attention to their appearance. They are simply just a location to park the automobiles and store the extra boxes of Xmas decorations and such. However, like any other room in your house your storage floor needs to be taken care and attention of.
Due to the utilize it gets, combined with drinking water, gas and essential oil that will inevitable be spilled upon it, garage floor can simply become destroyed and start to fall apart after a few years useful. Epoxy layer is one answer to your garage flooring challenge. Epoxy layer applies a level of sealant and protectant to your concrete garage floor to make it withstand staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floors requires a little up-front preparation before beginning. The most important step in the process is making sure that the ground you are going to apply the epoxy coating onto is free of moisture, residual color and doesn’t have a concrete sealer or other concluding put on it.
To test for moisture, take a sheet of plastic material and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for about two times and then remove and look for any moisture collecting on the side of the plastic material facing the ground. If moisture exists, than an epoxy floor finish is not suitable as epoxy requires a dried surface to properly relationship with the floors.
Next, we’ll test to make certain the flooring doesn’t have a sealant already put on it. This test will also check for the occurrence of natural oils in the cement as well. Take a cup of drinking water and put it immediately onto the existing flooring. It will soak into the floor in a reasonable timeframe. If it beads or maybe sits together with the flooring then your floors has probably recently been sealed or contains oil contaminants. Epoxy flooring is not well suited for cement floors that have already been sealed or contain any kind of petrol residue as you won’t bond.
Finally, if you are prepared to spend almost a year testing a location of your storage floor for suitability to putting in epoxy floor coverings you can coloring a small area with regular, oil-based teeth enamel. If this test area lasts for several months then chances are an epoxy coating can last as well. However, if you opt to proceed with applying the epoxy layer you’ll need to eliminate this enamel coating which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *