application of Epoxy flooring to a Garage surface

Many times we don’t believe about our garages or pay much focus on their appearance. They are merely a location to park the autos and store the excess boxes of Xmas accessories and such. However, like any other room in your own home your storage floor must be taken care and attention of.
Due to the make use of it gets, combined with water, gas and oil that will unavoidable be spilled after it, garage floors can certainly become destroyed and start to fall apart after a few years of use. Epoxy finish is one method for your garage floor challenge. Epoxy finish applies a part of sealant and protectant to your concrete storage area floor to help it resist staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring requires a little up-front planning before beginning. The main step in the process is ensuring the ground you are going to apply the epoxy coating onto is free of moisture, residual paint and does not have a concrete sealer or other completing applied to it.
To check for moisture, take a sheet of plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two days and then remove and check for any moisture collecting privately of the plastic material facing the floor. If moisture is present, than an epoxy flooring finish is not suited as epoxy needs a dry surface to properly connection with the floor coverings.
Next, we’ll test to be sure the flooring doesn’t have a sealant already put on it. This test will also check for the presence of natural oils in the cement as well. Have a cup of water and put it directly onto the prevailing flooring. It should soak into the floor in an acceptable timeframe. If it beads or simply sits on top of the flooring then your floor has probably recently been sealed or contains oil contaminants. Epoxy floors is not ideal for cement floors that contain already been sealed or contain any type of engine oil residue as it will not bond.
Finally, if you are prepared to spend almost a year testing a location of your storage floor for suitability to putting in epoxy floor you can coloring a small area with regular, oil-based teeth enamel. If this test area is maintained for several months then chances are an epoxy layer can last as well. However, if you opt to proceed with applying the epoxy coating you will need to eliminate this enamel coating which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *