application of Epoxy paint to the Garage Flooring

Often we don’t believe about our garages or pay much focus on the look of them. They are simply just a location to park the cars and store the excess boxes of Christmas decor and such. However, like any other room in your own home your garage floor needs to be taken health care of.
Due to the use it gets, combined with normal water, gas and engine oil that will unavoidable be spilled after it, garage floor coverings can certainly become ruined and begin to fall apart over time of use. Epoxy coating is one treatment for your garage floor coverings challenge. Epoxy layer applies a layer of sealant and protectant to your concrete car port floor to help it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring requires a little up-front planning before beginning. The main step in the process is making sure that the floor you will apply the epoxy coating onto is free of moisture, residual paint and doesn’t have a cement sealer or other concluding put on it.
To test for moisture, take a sheet of plastic material and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two days and then remove and look for any moisture collecting privately of the plastic material facing the floor. If moisture is present, than an epoxy floors finish is not appropriate as epoxy needs a dried up surface to properly relationship with the floor.
Next, we’ll test to make sure the flooring does not have a sealant already applied to it. This test will also look for the existence of natural oils in the concrete as well. Have a cup of water and put it directly onto the prevailing flooring. It should soak into the floor in a reasonable timeframe. If it beads or just sits together with the flooring then your floor coverings has probably already been sealed or consists of oil impurities. Epoxy floor coverings is not suited to cement floors which may have already been sealed or contain any kind of olive oil residue as you won’t bond.
Finally, if you are prepared to spend almost a year testing a location of your storage floor for suitability to installing epoxy flooring you can coloring a tiny area with regular, oil-based teeth enamel. If this test area can last for several weeks then it is likely an epoxy layer can last as well. However, if you decide to proceed with making use of the epoxy layer you will need to eliminate this enamel layer which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *