using Epoxy flooring to a Garage Flooring

Often we don’t think about our garages or pay much focus on the look of them. They are merely a location to park the automobiles and store the extra boxes of Christmas decor and such. However, like any other room in your own home your garage floor must be taken health care of.
Due to the make use of it gets, combined with normal water, gas and oil that will unavoidable be spilled after it, garage floor coverings can simply become ruined and get started to break apart after a few years useful. Epoxy coating is one treatment for your garage floor coverings challenge. Epoxy finish applies a level of sealant and protectant to your concrete car port floor to make it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring takes a little up-front preparation before beginning. The main step in the procedure is making sure that the ground you are going to apply the epoxy coating onto is free from moisture, residual car paint and doesn’t have a concrete sealer or other finishing applied to it.
To test for moisture, have a sheet of clear plastic and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and look for any moisture collecting on the side of the plastic facing the floor. If moisture is present, than an epoxy floor coverings layer is not suited as epoxy requires a dried up surface to properly connection with the floor.
Next, we’ll test to make sure the flooring doesn’t have a sealant already put on it. This test will also check for the existence of oils in the cement as well. Take a cup of water and pour it immediately onto the existing flooring. It should soak in to the floor in an acceptable amount of time. If it beads or maybe sits on top of the flooring then the floors has probably recently been sealed or consists of oil pollutants. Epoxy floor is not well suited for cement floors which have already been closed or contain any type of oil residue as you won’t bond.
Finally, if you are willing to spend several months testing a location of your garage floor for suitability to setting up epoxy flooring you can paint a tiny area with regular, oil-based enamel. If this test area continues for several months then it is likely an epoxy layer can last as well. However, if you decide to proceed with making use of the epoxy finish you will need to eliminate this enamel coating that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *