Applying Epoxy flooring to any Garage floor

Many times we don’t think about our garages or pay much attention to their appearance. They are simply just a location to park the vehicles and store the extra boxes of Holiday designs and such. However, like any other room in your own home your garage floor needs to be taken treatment of.
Due to the utilize it gets, coupled with water, gas and olive oil that will inevitable be spilled after it, garage flooring can easily become broken and commence to break apart over time useful. Epoxy covering is one method for your garage floors challenge. Epoxy finish applies a coating of sealant and protectant to your concrete garage area floor to help it avoid staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor coverings takes a little up-front planning before beginning. The most important step in the procedure is ensuring the ground you are going to apply the epoxy covering onto is free of moisture, residual car paint and doesn’t have a concrete sealer or other concluding applied to it.
To check for moisture, take a sheet of clear plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two days and then remove and check for any moisture collecting on the side of the plastic material facing the floor. If moisture is present, than an epoxy floor coverings finish is not appropriate as epoxy needs a dried surface to properly connection with the floor coverings.
Next, we’ll test to make sure the flooring does not have a sealant already put on it. This test will also look for the occurrence of natural oils in the cement as well. Have a cup of drinking water and put it straight onto the prevailing flooring. It should soak in to the floor in an acceptable timeframe. If it beads or just sits together with the flooring then the floors has probably recently been sealed or consists of oil impurities. Epoxy floor is not well suited for cement floors which may have already been sealed or contain any type of essential oil residue as you won’t bond.
Finally, if you are willing to spend several months testing an area of your storage area floor for suitability to installing epoxy floor you can color a small area with regular, oil-based teeth enamel. If this test area is maintained for several months then chances are an epoxy covering will last as well. However, if you opt to proceed with applying the epoxy coating you will need to eliminate this enamel coating that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *