application of Epoxy flooring to any Garage surface

Often we don’t think about our garages or pay much attention to their appearance. They are merely a place to park the automobiles and store the extra boxes of Christmas adornments and such. However, like any other room in your own home your garage area floor must be taken health care of.
Due to the make use of it gets, coupled with normal water, gas and essential oil that will unavoidable be spilled after it, garage flooring may easily become destroyed and commence to break apart over time useful. Epoxy covering is one method for your garage floor challenge. Epoxy finish applies a layer of sealant and protectant to your concrete garage floor to make it resist staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor coverings takes a little up-front preparation before beginning. The main step in the process is making sure that the ground you will apply the epoxy finish onto is free from moisture, residual coloring and doesn’t have a concrete sealer or other finishing put on it.
To check for moisture, have a sheet of plastic and take it to a 3-feet x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and check for any moisture collecting on the side of the vinyl facing the floor. If moisture is present, than an epoxy floor coating is not suitable as epoxy requires a dried out surface to properly connection with the floors.
Next, we’ll test to ensure the flooring doesn’t have a sealant already put on it. This test will also look for the presence of oils in the concrete as well. Have a cup of water and put it straight onto the existing flooring. It should soak into the floor in a reasonable timeframe. If it beads or perhaps sits on top of the flooring then the flooring has probably already been sealed or contains oil contaminants. Epoxy floor coverings is not well suited for cement floors which have already been closed or contain any kind of petrol residue as you won’t bond.
Finally, if you are willing to spend several months testing an area of your storage area floor for suitability to installing epoxy floors you can paint a small area with regular, oil-based enamel. If this test area lasts for several calendar months then chances are an epoxy covering will last as well. However, if you opt to proceed with applying the epoxy layer you’ll need to remove this enamel coating that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *