using Epoxy flooring to Your Garage surface

Often we don’t think about our garages or pay much attention to the look of them. They are merely a destination to park the vehicles and store the extra boxes of Holiday decor and such. However, like any other room in your house your garage floor must be taken care and attention of.
Because of the make use of it gets, combined with water, gas and olive oil that will inevitable be spilled upon it, garage floor can easily become damaged and get started to fall apart over time useful. Epoxy layer is one method for your garage floor coverings challenge. Epoxy coating applies a covering of sealant and protectant to your concrete storage floor to help it resist staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor coverings takes a little up-front planning before beginning. The most important step in the process is ensuring the ground you are going to apply the epoxy coating onto is free from moisture, residual color and does not have a cement sealer or other completing applied to it.
To check for moisture, have a sheet of plastic material and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for approximately two days and then remove and look for any moisture collecting on the side of the vinyl facing the floor. If moisture exists, than an epoxy floor finish is not suited as epoxy requires a dried surface to properly bond with the flooring.
Next, we’ll test to ensure the flooring does not have a sealant already applied to it. This test will also check for the existence of natural oils in the cement as well. Take a cup of normal water and pour it directly onto the prevailing flooring. It will soak into the floor in an acceptable amount of time. If it beads or just sits on top of the flooring then the floor coverings has probably recently been sealed or consists of oil pollutants. Epoxy floor coverings is not suitable for cement floors which may have already been sealed or contain any type of essential oil residue as you won’t bond.
Finally, if you are willing to spend almost a year testing an area of your storage area floor for suitability to setting up epoxy floor coverings you can paint a tiny area with regular, oil-based teeth enamel. If this test area continues for several months then chances are an epoxy finish can last as well. However, if you decide to proceed with applying the epoxy coating you will need to eliminate this enamel covering that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *