Applying Epoxy Coatings to any Garage floor

Often we don’t think about our garages or pay much attention to the look of them. They are merely a destination to park the autos and store the excess boxes of Xmas decor and such. However, like any other room in your own home your garage area floor must be taken treatment of.
Because of the utilize it gets, coupled with normal water, gas and petrol that will inevitable be spilled upon it, garage floors can certainly become broken and start to fall apart over time useful. Epoxy layer is one solution to your garage floor challenge. Epoxy covering applies a coating of sealant and protectant to your concrete storage floor to help it withstand staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor takes a little up-front preparation before beginning. The main step in the process is ensuring the floor you are going to apply the epoxy finish onto is free of moisture, residual car paint and doesn’t have a cement sealer or other concluding applied to it.
To check for moisture, have a sheet of plastic material and take it to a 3-foot x 3-foot area using masking tape. Keep it there for about two days and then remove and look for any moisture collecting privately of the plastic facing the floor. If moisture exists, than an epoxy floors covering is not suitable as epoxy requires a dried out surface to properly connection with the floors.
Next, we’ll test to be sure the flooring doesn’t have a sealant already applied to it. This test will also check for the occurrence of natural oils in the concrete as well. Take a cup of drinking water and put it straight onto the prevailing flooring. It will soak into the floor in a reasonable amount of time. If it beads or just sits on top of the flooring then the floor coverings has probably recently been sealed or includes oil contaminants. Epoxy floor coverings is not well suited for cement floors which may have already been closed or contain any kind of petrol residue as you won’t bond.
Finally, if you are willing to spend several months testing an area of your storage area floor for suitability to setting up epoxy flooring you can color a little area with regular, oil-based enamel. If this test area lasts for several months then chances are an epoxy layer will last as well. However, if you opt to proceed with making use of the epoxy coating you will need to eliminate this enamel covering that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *