using Epoxy Coatings to a Garage surface

Often we don’t believe about our garages or pay much focus on the look of them. They are simply just a location to park the vehicles and store the excess boxes of Holiday accessories and such. However, like any other room in your own home your storage area floor needs to be taken good care of.
Due to the use it gets, combined with drinking water, gas and olive oil that will inevitable be spilled upon it, garage floor coverings may easily become harmed and commence to fall apart over time of use. Epoxy covering is one means to fix your garage floors challenge. Epoxy coating applies a coating of sealant and protectant to your concrete storage floor to help it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy floors requires a little up-front preparation before beginning. The main step in the process is ensuring the floor you are going to apply the epoxy layer onto is free of moisture, residual color and does not have a concrete sealer or other completing applied to it.
To test for moisture, have a sheet of plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two times and then remove and look for any moisture collecting on the side of the vinyl facing the ground. If moisture is present, than an epoxy floors finish is not ideal as epoxy needs a dried out surface to properly connection with the floor coverings.
Next, we’ll test to ensure the flooring doesn’t have a sealant already applied to it. This test will also check for the presence of oils in the concrete as well. Take a cup of normal water and pour it directly onto the existing flooring. It should soak in to the floor in an acceptable amount of time. If it beads or perhaps sits together with the flooring then your flooring has probably already been sealed or has oil contaminants. Epoxy floors is not ideal for cement floors that contain already been closed or contain any type of oil residue as you won’t bond.
Finally, if you are willing to spend several months testing a location of your garage area floor for suitability to putting in epoxy floor you can color a tiny area with regular, oil-based enamel. If this test area continues for several calendar months then it is likely an epoxy layer will last as well. However, if you decide to proceed with making use of the epoxy layer you’ll need to remove this enamel layer that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *