application of Epoxy Coatings to a Garage floor

Often we don’t believe about our garages or pay much attention to the look of them. They are simply just a destination to park the automobiles and store the extra boxes of Holiday adornments and such. However, like any other room in your own home your garage floor must be taken care and attention of.
Due to the use it gets, coupled with normal water, gas and petrol that will unavoidable be spilled upon it, garage floor coverings may easily become destroyed and start to break apart after a few years of use. Epoxy finish is one method for your garage floors challenge. Epoxy finish applies a level of sealant and protectant to your concrete car port floor to make it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor coverings requires a little up-front preparation before beginning. The main step in the process is making sure that the floor you are going to apply the epoxy coating onto is free of moisture, residual coloring and does not have a cement sealer or other finishing applied to it.
To check for moisture, take a sheet of vinyl and take it to a 3-foot x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and check for any moisture collecting on the side of the vinyl facing the floor. If moisture exists, than an epoxy floors finish is not ideal as epoxy requires a dried out surface to properly bond with the floor coverings.
Next, we’ll test to ensure the flooring does not have a sealant already applied to it. This test will also look for the existence of oils in the concrete as well. Have a cup of normal water and put it directly onto the existing flooring. It should soak in to the floor in a reasonable timeframe. If it beads or maybe sits on top of the flooring then your floor has probably already been sealed or is made up of oil contaminants. Epoxy flooring is not suitable for cement floors that have already been closed or contain any kind of olive oil residue as it will not bond.
Finally, if you are willing to spend almost a year testing an area of your car port floor for suitability to putting in epoxy floor you can coloring a little area with regular, oil-based teeth enamel. If this test area will last for several a few months then chances are an epoxy layer can last as well. However, if you opt to proceed with making use of the epoxy layer you will need to eliminate this enamel covering which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *