Applying Epoxy paint to the Garage floor

Often we don’t think about our garages or pay much attention to the look of them. They are simply just a spot to park the automobiles and store the excess boxes of Xmas decorations and such. However, like any other room in your own home your storage area floor must be taken good care of.
Due to the make use of it gets, coupled with drinking water, gas and petrol that will unavoidable be spilled after it, garage floors can certainly become ruined and begin to fall apart after a few years of use. Epoxy coating is one answer to your garage floor coverings challenge. Epoxy finish applies a layer of sealant and protectant to your concrete storage area floor to help it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring requires a little up-front prep before beginning. The most important step in the procedure is making sure that the ground you are going to apply the epoxy coating onto is free from moisture, residual paint and does not have a cement sealer or other concluding applied to it.
To check for moisture, take a sheet of vinyl and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and check for any moisture collecting privately of the clear plastic facing the ground. If moisture is present, than an epoxy floor covering is not suited as epoxy requires a dry out surface to properly bond with the floors.
Next, we’ll test to ensure the flooring does not have a sealant already put on it. This test will also look for the presence of oils in the concrete as well. Have a cup of normal water and pour it directly onto the existing flooring. It should soak in to the floor in an acceptable amount of time. If it beads or perhaps sits on top of the flooring then your floor has probably already been sealed or is made up of oil pollutants. Epoxy floor coverings is not ideal for cement floors that contain already been covered or contain any type of olive oil residue as it will not bond.
Finally, if you are prepared to spend almost a year testing a location of your car port floor for suitability to setting up epoxy floor you can paint a small area with regular, oil-based teeth enamel. If this test area can last for several months then chances are an epoxy coating will last as well. However, if you opt to proceed with making use of the epoxy covering you will need to remove this enamel covering which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *