Applying Epoxy paint to a Garage floor

Many times we don’t believe about our garages or pay much attention to their appearance. They are merely a destination to park the autos and store the excess boxes of Christmas adornments and such. However, like any other room in your house your storage floor needs to be taken attention of.
Due to the make use of it gets, combined with drinking water, gas and olive oil that will inevitable be spilled after it, garage flooring can certainly become damaged and commence to fall apart after a few years useful. Epoxy finish is one treatment for your garage flooring challenge. Epoxy coating applies a layer of sealant and protectant to your concrete garage area floor to make it resist staining, moisture problems and helps it maintain its appearance.
Installing epoxy floors requires a little up-front preparation before beginning. The main step in the procedure is making sure that the floor you are going to apply the epoxy finish onto is free from moisture, residual coloring and doesn’t have a cement sealer or other concluding applied to it.
To check for moisture, take a sheet of clear plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and check for any moisture collecting on the side of the plastic facing the floor. If moisture is present, than an epoxy flooring layer is not ideal as epoxy needs a dried surface to properly bond with the floors.
Next, we’ll test to make sure the flooring doesn’t have a sealant already applied to it. This test will also check for the occurrence of natural oils in the cement as well. Have a cup of water and put it directly onto the prevailing flooring. It should soak in to the floor in a reasonable timeframe. If it beads or just sits on top of the flooring then the floors has probably already been sealed or includes oil pollutants. Epoxy floors is not suited to cement floors which have already been sealed or contain any kind of oil residue as it will not bond.
Finally, if you are willing to spend several months testing an area of your storage area floor for suitability to setting up epoxy flooring you can color a little area with regular, oil-based teeth enamel. If this test area will last for several weeks then it is likely an epoxy layer will last as well. However, if you opt to proceed with making use of the epoxy finish you will need to remove this enamel covering that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *