Applying Epoxy flooring to a Garage surface

Many times we don’t think about our garages or pay much attention to the look of them. They are simply just a location to park the automobiles and store the excess boxes of Holiday decorations and such. However, like any other room in your own home your garage area floor needs to be taken health care of.
Due to the use it gets, combined with normal water, gas and oil that will inevitable be spilled upon it, garage floors may easily become broken and begin to fall apart over time of use. Epoxy finish is one answer to your garage flooring challenge. Epoxy covering applies a covering of sealant and protectant to your concrete car port floor to help it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor coverings takes a little up-front prep before beginning. The main step in the procedure is making sure that the ground you are going to apply the epoxy coating onto is free from moisture, residual color and does not have a concrete sealer or other completing applied to it.
To test for moisture, take a sheet of plastic material and take it to a 3-feet x 3-foot area using masking tape. Keep it there for approximately two days and then remove and look for any moisture collecting privately of the plastic facing the ground. If moisture is present, than an epoxy floor covering is not suitable as epoxy needs a dry out surface to properly connection with the floor coverings.
Next, we’ll test to ensure the flooring doesn’t have a sealant already applied to it. This test will also look for the presence of natural oils in the concrete as well. Take a cup of water and put it directly onto the prevailing flooring. It should soak in to the floor in a reasonable timeframe. If it beads or maybe sits together with the flooring then your floor coverings has probably recently been sealed or contains oil pollutants. Epoxy floor coverings is not well suited for cement floors that contain already been closed or contain any type of essential oil residue as you won’t bond.
Finally, if you are prepared to spend almost a year testing an area of your garage floor for suitability to installing epoxy floors you can coloring a small area with regular, oil-based teeth enamel. If this test area can last for several months then chances are an epoxy covering will last as well. However, if you decide to proceed with applying the epoxy finish you will need to remove this enamel finish that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *