Applying Epoxy Coatings to Your Garage surface

Many times we don’t think about our garages or pay much focus on the look of them. They are simply just a location to park the vehicles and store the extra boxes of Xmas adornments and such. However, like any other room in your house your storage area floor needs to be taken care and attention of.
Due to the utilize it gets, coupled with drinking water, gas and engine oil that will inevitable be spilled after it, garage floor can easily become damaged and get started to fall apart after a few years of use. Epoxy layer is one way to your garage flooring challenge. Epoxy coating applies a level of sealant and protectant to your concrete storage floor to make it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor takes a little up-front preparation before beginning. The most important step in the procedure is ensuring the ground you will apply the epoxy covering onto is free from moisture, residual color and does not have a concrete sealer or other completing put on it.
To check for moisture, have a sheet of plastic and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for approximately two times and then remove and check for any moisture collecting on the side of the vinyl facing the floor. If moisture is present, than an epoxy floors finish is not suited as epoxy requires a dried out surface to properly connection with the floors.
Next, we’ll test to ensure the flooring does not have a sealant already applied to it. This test will also check for the existence of natural oils in the concrete as well. Have a cup of water and put it straight onto the prevailing flooring. It should soak into the floor in a reasonable timeframe. If it beads or just sits on top of the flooring then your flooring has probably recently been sealed or has oil contaminants. Epoxy flooring is not suitable for cement floors which have already been sealed or contain any type of petrol residue as you won’t bond.
Finally, if you are willing to spend almost a year testing an area of your car port floor for suitability to installing epoxy floor coverings you can paint a tiny area with regular, oil-based enamel. If this test area continues for several weeks then chances are an epoxy finish can last as well. However, if you decide to proceed with applying the epoxy covering you will need to remove this enamel covering that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *