using Epoxy Coatings to a Garage floor

Often we don’t believe about our garages or pay much focus on the look of them. They are merely a destination to park the vehicles and store the extra boxes of Christmas decor and such. However, like any other room in your house your garage floor needs to be taken treatment of.
Due to the put it to use gets, coupled with normal water, gas and petrol that will inescapable be spilled after it, garage floor can certainly become broken and commence to fall apart over time of use. Epoxy covering is one treatment for your garage floor coverings challenge. Epoxy coating applies a covering of sealant and protectant to your concrete garage area floor to make it resist staining, moisture problems and helps it maintain its appearance.
Installing epoxy flooring requires a little up-front preparation before beginning. The main step in the process is ensuring the ground you are going to apply the epoxy covering onto is free from moisture, residual car paint and does not have a cement sealer or other concluding applied to it.
To test for moisture, take a sheet of plastic material and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and check for any moisture collecting privately of the plastic facing the ground. If moisture exists, than an epoxy flooring coating is not ideal as epoxy needs a dried out surface to properly connection with the floor.
Next, we’ll test to be sure the flooring does not have a sealant already applied to it. This test will also check for the existence of oils in the cement as well. Have a cup of water and put it directly onto the existing flooring. It will soak into the floor in a reasonable amount of time. If it beads or just sits together with the flooring then the flooring has probably recently been sealed or consists of oil impurities. Epoxy floor is not ideal for cement floors that contain already been covered or contain any kind of oil residue as it will not bond.
Finally, if you are prepared to spend almost a year testing a location of your storage area floor for suitability to putting in epoxy floor you can paint a small area with regular, oil-based teeth enamel. If this test area endures for several calendar months then it is likely an epoxy layer can last as well. However, if you decide to proceed with applying the epoxy finish you will need to eliminate this enamel finish that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *