application of Epoxy paint to Your Garage floors

Many times we don’t believe about our garages or pay much focus on their appearance. They are simply just a location to park the autos and store the excess boxes of Holiday decor and such. However, like any other room in your own home your storage floor must be taken good care of.
Due to the put it to use gets, coupled with drinking water, gas and engine oil that will unavoidable be spilled upon it, garage flooring can simply become harmed and get started to fall apart after a few years useful. Epoxy finish is one way to your garage flooring challenge. Epoxy coating applies a layer of sealant and protectant to your concrete storage area floor to help it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy floors requires a little up-front preparation before beginning. The most important step in the process is making sure that the floor you are going to apply the epoxy finish onto is free from moisture, residual paint and does not have a concrete sealer or other concluding put on it.
To check for moisture, take a sheet of clear plastic and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and check for any moisture collecting on the side of the clear plastic facing the floor. If moisture is present, than an epoxy floor coverings coating is not suited as epoxy needs a dry out surface to properly bond with the flooring.
Next, we’ll test to make certain the flooring does not have a sealant already put on it. This test will also look for the existence of natural oils in the concrete as well. Take a cup of water and pour it straight onto the prevailing flooring. It should soak into the floor in an acceptable timeframe. If it beads or just sits on top of the flooring then your floors has probably recently been sealed or contains oil impurities. Epoxy floor is not suited to cement floors that have already been closed or contain any type of petrol residue as it will not bond.
Finally, if you are willing to spend almost a year testing a location of your storage floor for suitability to setting up epoxy floor you can coloring a little area with regular, oil-based teeth enamel. If this test area is maintained for several calendar months then chances are an epoxy layer can last as well. However, if you decide to proceed with making use of the epoxy layer you will need to eliminate this enamel coating that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *