If you’ve ever considered by using a garage floor epoxy system to safeguard and enhance the look of your car port floor, there are many things you should know before purchasing one. Most diy stores take epoxy floor sets made for the do-it-yourselfer and you might have heard differing viewpoints on how well they work. Some will say it’s a fantastic product while others will tell you not to squander your cash. Well, you can find usually a fairly easy explanation as to why this product fails for a few floors.
One reason behind failure is don’t assume all concrete floor is perfect for applying an epoxy coating. Many floor surfaces have too much hydrostatic pressure, signifying water steps from the under the slab up to the top in a process called capillary action. Moisture then collects on the top, which breaks the bond between the cement and the epoxy jacket. If the floor “sweats” even when it’s dry outdoors or there are areas that seem to be to stay moist for extended periods of time, then an epoxy coating will likely fail. It’ll slowly but surely chip and flake away. Even though you don’t think there’s a moisture problem, it’s a good idea to use an efflorescence or salt blocker prior to the epoxy. This will help prevent wetness from leading to problems.
The most possible reason for inability is improper surface preparation. The ground must be completely clean and stripped of all other coatings. Any staining or foreign chemicals (olive oil, grease, color, etc.) will prevent satisfactory bonding between the concrete and epoxy, resulting in chipping and flaking. Most contractors will apply a overcoat of sealer to a storage floor after assembly. Normally it takes many years for the sealer to wear off completely. This sealer must be removed for epoxy to previous. Although acid solution etching can be an important step, it will not remove sealer and most stains. Etching will only open up the pores of bare concrete, therefore you should do all cleaning and stripping before etching with acid solution.
Before purchasing a garage area floor epoxy system, you will need to first decide if your floor is right for it. If it sweats often or there are areas that are constantly moist, then forget about it. Make sure that you are prepared to take time to prep the floor properly, as this is the most significant part. In addition, it really helps to put one or two coats of clear concrete sealer at the top to serve as a wear layer. Water established acrylic sealers are suitable for indoor residential use. Despite any bad reviews you’ve heard about the do-it-yourself garage area floor epoxy system, it can be a successful project if it’s done correctly.