Applying Epoxy flooring to a Garage floor

Often we don’t believe about our garages or pay much attention to the look of them. They are simply just a place to park the autos and store the extra boxes of Christmas decorations and such. However, like any other room in your own home your garage floor needs to be taken good care of.
Due to the use it gets, coupled with normal water, gas and engine oil that will inevitable be spilled after it, garage floor can easily become destroyed and get started to fall apart after a few years of use. Epoxy finish is one solution to your garage floor coverings challenge. Epoxy covering applies a covering of sealant and protectant to your concrete storage area floor to help it avoid staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor takes a little up-front prep before beginning. The main step in the process is making sure that the floor you will apply the epoxy finish onto is free of moisture, residual coloring and doesn’t have a cement sealer or other completing applied to it.
To test for moisture, have a sheet of vinyl and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for about two days and then remove and check for any moisture collecting privately of the plastic facing the ground. If moisture is present, than an epoxy flooring covering is not appropriate as epoxy requires a dry surface to properly bond with the floors.
Next, we’ll test to make certain the flooring does not have a sealant already applied to it. This test will also check for the existence of oils in the concrete as well. Have a cup of normal water and pour it immediately onto the existing flooring. It will soak in to the floor in a reasonable amount of time. If it beads or maybe sits on top of the flooring then your floor has probably recently been sealed or has oil pollutants. Epoxy flooring is not well suited for cement floors that contain already been covered or contain any kind of engine oil residue as you won’t bond.
Finally, if you are willing to spend almost a year testing an area of your car port floor for suitability to putting in epoxy floor coverings you can coloring a tiny area with regular, oil-based enamel. If this test area will last for several weeks then it is likely an epoxy coating can last as well. However, if you decide to proceed with applying the epoxy covering you’ll need to remove this enamel coating that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *