Applying Epoxy Coatings to Your Garage floors

Many times we don’t believe about our garages or pay much focus on their appearance. They are simply just a destination to park the vehicles and store the excess boxes of Xmas adornments and such. However, like any other room in your own home your storage floor must be taken care and attention of.
Because of the put it to use gets, coupled with normal water, gas and petrol that will unavoidable be spilled upon it, garage floor coverings can easily become destroyed and begin to fall apart after a few years of use. Epoxy covering is one answer to your garage floor challenge. Epoxy covering applies a level of sealant and protectant to your concrete storage area floor to make it withstand staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy flooring takes a little up-front preparation before beginning. The main step in the procedure is making sure that the floor you will apply the epoxy covering onto is free from moisture, residual paint and does not have a concrete sealer or other completing put on it.
To test for moisture, have a sheet of clear plastic and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two days and then remove and look for any moisture collecting on the side of the vinyl facing the ground. If moisture exists, than an epoxy floors covering is not ideal as epoxy requires a dry surface to properly relationship with the floor.
Next, we’ll test to ensure the flooring does not have a sealant already put on it. This test will also check for the existence of oils in the concrete as well. Take a cup of drinking water and pour it immediately onto the prevailing flooring. It should soak in to the floor in an acceptable timeframe. If it beads or simply sits together with the flooring then your flooring has probably already been sealed or includes oil pollutants. Epoxy floor is not well suited for cement floors that contain already been sealed or contain any type of oil residue as you won’t bond.
Finally, if you are willing to spend several months testing an area of your storage floor for suitability to putting in epoxy floor coverings you can paint a little area with regular, oil-based teeth enamel. If this test area will last for several a few months then chances are an epoxy layer can last as well. However, if you opt to proceed with applying the epoxy covering you’ll need to eliminate this enamel coating which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *