If you’ve ever considered using a garage floor epoxy system to protect and improve the look of your storage area floor, there are a few things you need to understand before purchasing one. Most diy stores take epoxy floor kits suitable for the do-it-yourselfer and you might have heard differing thoughts on how well they work. Some will say it’s a great product as well as others will tell you not to waste materials your money. Well, there may be usually an easy explanation as to the reasons this product fails for a few floors.
One reason for failure is don’t assume all concrete floor is suitable for making use of an epoxy covering. Many floor surfaces have too much hydrostatic pressure, signifying water goes from the under the slab up to the top in an activity called capillary action. Wetness then collects on the surface, which breaks the relationship between the cement and the epoxy coating. If the floor “sweats” even though it’s dry outside the house or there are areas that seem to be to stay damp for long periods of time, then an epoxy coating will almost certainly fail. It’ll steadily chip and flake away. Even though you don’t think there is a moisture problem, it’s a good idea to apply an efflorescence or sodium blocker before the epoxy. This will help prevent water from creating problems.
The most probable reason for failure is incorrect surface preparation. The ground must be completely clean and stripped of most other coatings. Any staining or foreign substances (oil, grease, coloring, etc.) will prevent satisfactory bonding between your cement and epoxy, resulting in chipping and flaking. Most companies will apply a overcoat of sealer to a garage area floor after unit installation. It can take several years for the sealer to wear off completely. This sealer must be removed for epoxy to previous. Although acid solution etching can be an important step, you won’t remove sealer & most stains. Etching is only going to start the skin pores of bare concrete, therefore you should do all cleaning and stripping before etching with acid.
Before investing in a garage floor epoxy system, you need to first decide if your floor is right for it. If it sweats often or there are areas that are constantly wet, then forget about it. Make sure that you are prepared to take the time to prep the floor properly, as this is the most critical part. It also really helps to put one or two coats of clear concrete sealer at the top to serve as a wear overcoat. Water structured acrylic sealers are suitable for indoor domestic use. Despite any bad reviews you’ve heard about the do-it-yourself car port floor epoxy system, it’s rather a successful project whether it’s done correctly.