High Quality garage area for Epoxy System

If you’ve ever before considered by using a garage area floor epoxy system to protect and improve the look of your storage floor, there are many things you should know before purchasing one. Most diy stores carry epoxy floor sets created for the do-it-yourselfer and you’ve probably heard differing thoughts on how well they work. Some will say it’s a fantastic product among others will tell you not to waste your money. Well, there is certainly usually a fairly easy explanation as to the reasons this product fails for a few floors.
One reason behind failure is don’t assume all concrete floor is perfect for making use of an epoxy finish. Many floor surfaces have too much hydrostatic pressure, indicating water steps from the under the slab up to the top in an activity called capillary action. Dampness then gathers on the top, which breaks the relationship between the concrete and the epoxy coat. If the floor “sweats” even though it’s dry outdoors or there are areas that seem to be to stay damp for long periods of time, then an epoxy layer will likely fail. It will slowly but surely chip and flake away. Even if you don’t think there’s a moisture problem, it’s wise to use an efflorescence or salt blocker prior to the epoxy. This will help prevent moisture content from causing problems.

The most probable reason for failure is inappropriate surface preparation. The floor must be completely clean and stripped of all other coatings. Any spots or foreign substances (petrol, grease, coloring, etc.) will prevent satisfactory bonding between your cement and epoxy, resulting in chipping and flaking. Most companies will apply a coat of sealer to a storage floor after installation. It can take many years for the sealer to wear off completely. This sealer must be removed for epoxy to last. Although acid etching is an important step, it will not remove sealer & most stains. Etching will only open up the pores of bare cement, therefore you must do all cleaning and stripping before etching with acid.

Before investing in a car port floor epoxy system, you will need to first decide if your floor is right for it. If it sweats often or there are areas that are constantly damp, then just forget about it. Be sure that you are willing to take the time to prep the ground properly, as this is actually the most critical part. It also helps to put a couple of coats of clear concrete sealer at the top to serve as a wear cover. Water based acrylic sealers are perfect for indoor personal use. Despite any bad reviews you’ve found out about the do-it-yourself garage area floor epoxy system, it’s rather a successful project whether it’s done correctly.

Leave a Reply

Your email address will not be published. Required fields are marked *